Roland VS-2480 Owner's Manual Addendum page 80

8—VGA Main Display EZ ROUTING Screen
Input to Input Channel Mouse Routing
Input signal to input channel routing occurs in the EZ ROUTING PATCH BAY pane.
To make a new connection:
1. Position the mouse cursor over the desired input channel pair until the cursor
2. Click and drag the mouse to the desired pair of input jacks or connectors—a virtual
To change or delete an existing connection:
1. Position the mouse cursor over the desired input channel pair until the cursor
2. Position the mouse cursor over the desired input jack or connector pair until the
3. Click and drag the mouse left or right to select a new input channel pair or all the
Routing Signals to a Recording Track Using a Mouse
The procedures for routing a signal from an input channel, track channel, FX return
channel, Aux bus, Direct bus or generator (Owner's Manual Page 372) to a recording
tracks are the same, and take place in the TRACK ASSIGN EZ ROUTING pane.
To make a new connection:
1. Position the mouse cursor over the connection node you want to route to the track.
2. Click and drag the mouse to the desired recording track——a virtual cable appears
80 www.RolandUS.com
changes to a pointing finger.
cable appears onscreen to show the connection you're making, as shown above.
changes to a pointing finger and click once.
cursor changes to a pointing finger.
way to the left to delete the connection.
onscreen to show the connection you're making.
Roland VS-2480 Owner's Manual, Version Two Addendum