Track Channel Parameter Strip - Roland VS-2480 Owner's Manual Addendum

Track Channel Parameter Strip

1. Channel Name
2. STATUS Button
Click STATUS repeatedly to set the status of the
corresponding hard disk recorder track. This is the
same as clicking the track channel's TRACK STATUS
button on the VS-2480.
3. V.TRACK Selector
To select a different V-Track, click V.TRACK and
select the desired V-Track from the pop-up menu,
described on Page 41.
4. PHASE Button
Click PHASE—so it's lit—to reverse the phase
polarity of the channel's signal.
5. ATT Knob
To adjust the level of the signal coming into the track channel from
the hard disk recorder, drag the ATT knob up or down as desired—
the readout beneath the knob shows the current amount of
attenuation.
6. GROUP Selector
To assign the track channel to a fader group, click GROUP and
select the desired fader group from the pop-up menu.
7. CH LINK Button
To link the channel to its odd/even partner so that any changes
made to one channel affect both, click CH LINK to turn it on.
8. FDRLINK Button
Click FDRLINK—so it's lit—to link the current channel's fader to its
odd/even partner so their levels can be set by moving either fader
while their other parameters remain independently controllable.
9. AUTOMIX STATUS Button
Click the AUTOMIX STATUS button repeatedly to set the channel's
status as desired when Automix mode is on.
Roland VS-2480 Owner's Manual, Version Two Addendum
6—VGA Main Display CH VIEW Screens
178
151
154
www.RolandUS.com
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
153
155
152
155
327
55