Fx Return Channel Parameter Strip - Roland VS-2480 Owner's Manual Addendum

6—VGA Main Display CH VIEW Screens
10. PHRASE SEQ Status Button
Click the PHRASE SEQ status button repeatedly to set the channel's
phrase sequencer status as desired when Phrase Sequence mode is
activated.
9. PHRASE PAD Button
Click PHRASE PAD—so it's lit—to turn on the channel's phrase
pad.
9. PlyMod Selector
Click PlyMod and select the desired phrase pad play mode from the
pop-up menu.

FX Return Channel Parameter Strip

1. Channel Name
2. ASSIGN Selector
As shipped from the factory, each Aux bus is routed to
the input of its same-numbered effect processor. To
route a different Aux bus or a Direct bus to the FX
return channel's processor, click ASSIGN and select
the desired bus from the pop-up menu.
You can also do this by dragging the routing nodes in the LOOP
FX ASSIGN area of the screen, described on Page 61.
3. GROUP Selector
To assign the channel to a fader group, click GROUP
and select the desired group from the pop-up menu.
4. MONO Switch
By default, the output of an effect processor is stereo. To collapse its left
and right sides to a mono signal, click MONO so it lights.
5. AUTOMIX STATUS Button
Click the AUTOMIX STATUS button repeatedly to set the channel's
status as desired when Automix mode is on.
56 www.RolandUS.com Roland VS-2480 Owner's Manual, Version Two Addendum
275
274
274
228
228
228
327
1.
2.
3.
4.
5.