Aux Send Controls; Dir (Direct) 1-8 Selector - Roland VS-2480 Owner's Manual Addendum

The Input/Output Strip in Linked Channels
When channels are linked, a special SUB DISP ("SUB DISPLAY") button becomes
available at the bottom of the strip. You can control the two channels together or set
each channel's panning and level individually by clicking SUB DISP so it lights.

AUX Send Controls

The CH VIEW screens contain AUX send controls with which you can send the signal
from any input, track or FX return channel to any of the VS-2480's eight Aux busses. To:
•
•
•
When you change an Aux bus's pre/post setting, you're changing its setting for any
channel that's using it, as described on Owner's Manual Page 153.

DIR (DIRECT) 1-8 Selector

To assign an channel's signal to one of the eight Direct busses, click
the desired bus's button in the DIR 1-8 selector.
Roland VS-2480 Owner's Manual, Version Two Addendum
When SUB DISP is off,
a single silver balance
knob sets the overall
stereo positioning of
the linked signals. The
fader controls operate
together to set their
combined level.
turn on the send to an Aux bus—click the bus's Send Status button so it lights.
set an Aux send level—drag the Aux bus's Send Level knob up or down as desired.
change the pre/post configuration of an Aux bus—click the PRE/POST switch
repeatedly to select PRE or POST.
6—VGA Main Display CH VIEW Screens
SUB DISP button
When SUB DISP is on,
individual PAN knobs
become available, and
each fader controls the
level of its channel.
Send Status button
PRE/POST switch
Send level knob
www.RolandUS.com
208
53