Multi-Channel View Track Channels - Roland VS-2480 Owner's Manual Addendum

7—Mixer Views

Multi-Channel View Track Channels

1. V-Track Selector
Click the V-Track signal selector to assign the
desired V-Track to the track channel.
2. PHASE (INV) Button
Click the PHASE button so it lights to reverse the
phase polarity of the input channel's signal.
3. ATT Knob
Drag the ATT slider to adjust the level of the
signal coming into the channel. The signal's level
is shown to the left of the knob.
4. DYNAMICS (DYN) Switch and Overview
Turn on the channel's dynamics processor by clicking the DYN
switch so it lights. The currently selected type of dynamics
processor is shown beneath the switch along with the current
dynamics curve.
5. EQ Switch and Overview
Turn on the channel's EQ by clicking the EQ switch so it lights. The
current EQ curve appears below the switch.
6. AUX Send Sliders
Set the amount of the channel's signal sent to an Aux bus by adjusting
the corresponding AUX send slider. With linked Aux busses, a panning
handle replaces the even-numbered Aux bus's slider (Page 67).
7. DIR (DIRECT) 1-8 Buttons
To route the channel's signal to a Direct bus, click the desired bus's
number.
8. MUTE (M) Button
To mute the channel, click this button so it's lit. To un-mute the channel,
click the button again.
74 www.RolandUS.com Roland VS-2480 Owner's Manual, Version Two Addendum
151
6.
9.
8.
154
10.
11.
153
153
153
152
156
142
1.
2.
3.
4.
5.
7.
12.
13.
14.
15.
16.