To Receive A Call; To Use Directory Dialing; Directory Dialog Box - NEC Dterm PSIII User Manual

NOTE
NOTE
Figure 3-8 Directory dialog box
NOTE
Dterm PSIII User Guide - Revision 1

To Receive a Call

When you receive a call on your Dterm PSIII, the LED Ring Indicator will
flash (Figure 3-1).
If the Calling Party Number is not available, "CALL" is displayed. If Calling Party
Name is not available then the calling party number will appear in the display (only
for Mode 2* systems).
Press the L1 or L2* key (the line receiving the call).
Step 1
Begin speaking into the microphone.
Step 2
If you cannot answer a call, Missed Call is displayed.

To Use Directory Dialing

You can use Directory Dialing by searching for directory entries
manually or by name.
To Search for Directory Entries Manually
While in a standby state, press the Scroll
Step 1
displays (Figure
Directory
Press the Scroll
Step 2
press the Scroll
When you locate the desired name, press L1 or L2* to dial the number.
Step 3
*Mode 2 features are only available with NEAX 2000 (Series 1900 software or later)
and NEAX 2400 (Series 7300 software or later). Zone Transceiver 5.00 software (or
later) must be used.
To Search the Directory by Name
While in a standby state, press the Scroll
Step 1
displays (Figure
3-8).
key to search the Directory in alphabetical order or
key to search in reverse order.
3-8).
Using the PSIII 3-7
key. A Directory dialog box
key. A Directory dialog box