Change The Paper Size In The Optional Ohcf (Tray 6) - Xerox 4110 User Manual

Change the paper size in the optional OHCF (Tray 6)

X er o x 4 5 90 / 4110 C o pi e r /P r i n te r U s er G u i de
Load and align the edge of the paper against the right edge
5.
of the tray with the side to be copied or printed on facing up.
KEY POINT: Do not load paper exceeding the maximum fill line.
Doing so might cause paper jams or machine trouble.
6. Push the tray in gently until it comes to a stop.
NOTE: Affix the paper size label to the front of the paper tray.
NOTE: This optional tray is not available with the 4590 Copier/
Printer.
Pull out the tray towards you until it stops.
1.
WARNING: When pulling out the paper tray, do it slowly. If pulled
out with too much force, the tray can hit and injure your knees.
Remove any paper loaded on the tray.
2.
Squeeze the handle on the paper guide (A) and slide the
3.
guide to the desired paper size. Squeeze the handle on the
paper guide (B) and slide the guide to the desired paper
size.
Load and align the paper stack in the lower right corner of
4.
7. P a pe r an d O t he r M e di a
7-17