Emergency Puncture Repair Kit - Inflating The Tyres - Volvo V60 Plug-In Hybrid Owner's Manual
Hide thumbs
Also See for V60 Plug-In Hybrid:
- Owner's manual (696 pages) ,
- Quick manual (43 pages) ,
- Manual (86 pages)
Table of Contents
Advertisement
09 Wheels and tyres
||
09
NOTE
•
After a tyre has been inflated, always
refit the dust cap in order to avoid
damage to the valve from gravel, dirt,
etc.
•
Only use plastic dust caps. Metal dust
caps can rust and become difficult to
unscrew.
NOTE
The sealing fluid bottle and the hose must
be replaced after use. Volvo recommends
that this replacement is performed by an
authorised Volvo workshop.
WARNING
Check the tyre pressure regularly.
Volvo recommends that you drive to the near-
est authorised Volvo workshop for the
replacement/repair of the damaged tyre.
Advise the workshop that the tyre contains
sealing fluid.
Only 17" wheel Thia
6
324
WARNING
You should not drive faster than 80 km/h
after the emergency tyre repair kit has
been used. Volvo recommends that you
visit an authorised Volvo workshop for
inspection of the sealed tyre (maximum
driving distance is 200 km). The staff there
can determine whether or not the tyre can
be repaired or if it needs to be replaced.
Related information
•
Emergency puncture repair (p. 318)
•
Emergency puncture repair - operation (p.
320)
•
Emergency puncture repair kit - overview
(p. 320)
Emergency puncture repair kit -
inflating the tyres
The car's original tyres can be inflated using
the compressor in the emergency puncture
repair kit (p. 320).
1. The compressor must be switched off.
Make sure that the switch is in position 0
and locate the cable and air hose.
2. Remove the valve cover
6
- for instructions
on removing the valve cover, see (p. 321).
3. Unscrew the wheel's dust cap and screw
in the air hose valve connection to the
bottom of the thread on the tyre's air
valve.
WARNING
Inhaling car exhaust fumes could result in
danger to life. Never leave the engine run-
ning in sealed areas or areas that lack suf-
ficient ventilation.
WARNING
Do not leave children in the car without
supervision when the engine is running.
4. Connect the cable to one of the car's
12 V sockets and start the car.
Advertisement
Table of Contents
