Volvo V60 Plug-In Hybrid Owner's Manual page 318

09 Wheels and tyres
||
09
NOTE
•
After a tyre has been inflated, always
refit the dust cap in order to avoid
damage to the valve from gravel, dirt,
etc.
•
Only use plastic dust caps. Metal dust
caps can rust and become difficult to
unscrew.
WARNING
The bag should be secured so that the
white arrow (see the inset figure) points
forward in the car.
WARNING
Never crawl under the car when it is raised
on the jack.
Passengers must leave the car when it is
raised on the jack.
Park the car such that passengers have
the car, or ideally a crash barrier, between
themselves and the roadway.
Related information
•
Changing wheels - removing wheels (p.
312)
•
Jack* (p. 309)
•
Warning triangle (p. 317)
•
Wheel bolts (p. 308)
Only 17" wheel Thia
2
*
316
Option/accessory, for more information, see Introduction.
Tyres - air pressure
Tyres can have different air pressures which
are measured in bar.
Check the air pressure in the tyres
The tyre pressures must be checked every
month.
The tyre valve is covered by a plastic cover
2
which is equipped with a hole .
Remove the valve cover
1. Take the torx wrench (which is fitted in
the foam block behind the panel on the
left-hand side of the cargo area).
2. Press the torx wrench into the hole.
3. Prize off the cover using the torx wrench
.
4. Remove the valve cap.
Refit the valve cover
1. Fit the valve cap.
2. Press one edge of the cover (without the
hole) into place (nearest the tyre
3. Then fold the cover in toward the wheel
rim - and at the same time, gently press
down the angled top edge in order to
help it in under the edge of the wheel rim.
4. Check that the cover is flush with the sur-
face of the wheel rim - if not, gently press
in the part that is bulging out.
).