Toshiba Tecra M4 Maintenance Manual page 317

4 Replacement Procedure
Setting the bezel
1. Fit the bezel into the frame from the lamp side. ((1) in the bellow figure)
2. Hook the four (two positions on each side) latches on the side. ((2) in the bellow
figure)
3. Fit the bezel hooking the three latches on the upper side (FPC side). ((3) in the bellow
figure)
CAUTION: Be careful not to damage the cell, FPC and B/L.
(2) Hook
latches on the
side.
Figure 4-57 Replacing 14.1 Inch TMD fluorescent lamp (9)
4-86
(3) Hook the latch on the upper side and fit the bezel.
[CONFIDENTIAL]
4.32 Fluorescent lamp
TECRA M4 Maintenance Manual (960-521)
(2) Hook
latches on the
side.
(1) Fit
the bezel
from the
lamp
side.