Foxconn FlamingBlade GTI User Manual page 14

!
■ Make sure the power supply is turned off before pressing the CLR_CMOS button to
clear CMOS.
■ Push down the CLR_CMOS button and hold it there for a couple of seconds to clear
the CMOS completely, then release.
4. optical S/PDIF out Connector
This connector provides digital audio out to an external audio system that supports digital optical
audio.
5. external SATA Port (only for Flaming Blade)
To connect external SATA device(s) to your system by expanding the internal SATA port(s) to the
chassis back panel. External SATA device shall provide power by its own.
6. Audio Ports
For the definition of each audio port, please refer to the table below :
Port 2-channel
Blue Line In
Green Line Out
Pink Microphone In
Orange -
Black -
Grey -
7. RJ-45 lAN Port
Each Gigabit Ethernet LAN port provides Internet connection at up to 1Gb/s data rate.
Both Gigabit Ethernet LAN ports can be combined in teming mode to support connection speeds
up to 2Gb/s!
Left: Active
LAN Type
Status
Off
1000M
Green
Blinking
4-channel
Line In
Front Speaker Out
Microphone In
-
Rear Speaker Out
-
Description Status
No Link Off
Off
Data
Green
Activity
Orange
5.1-channel
Line In
Front Speaker Out
Microphone In
Center/Subwoofer Out
Rear Speaker Out
-
Right: Link
Description
No Link
10 Mb/s Connection
100 Mb/s Connection
1000 Mb/s Connection
7
7.1-channel
Line In
Front Speaker Out
Microphone In
Center/Subwoofer Out
Rear Speaker Out
Side Speaker Out
Active Link
LED LED