Receiver Status; A.indd - Garmin West Marine 276C Plus Owner's Manual

Portable color chartplotter
Hide thumbs Also See for West Marine 276C Plus:
Table of Contents

Advertisement

Signal
Strength
Bars
Sky view
The progress of satellite acquisition is shown in three stages:
• No signal strength bars—the receiver is looking for the
satellites indicated.
• White signal strength bars—the receiver has found the
satellite and is collecting data.
• Green signal strength bars—the receiver has collected the
necessary data from this satellite.
As soon as the 276C Plus has collected the necessary data from the
best satellites in view to calculate a fix, the status field indicates the
status of the receiver. The unit then updates the position, date and
time.

Receiver Status

The Receiver Status field displays one of the following conditions:
276C Plus Owner's Manual

190-00501-00_0A.indd 5

Receiver
Status
Field
Power
Source
Indicator
GPS Page
G
S
ETTING
TARTED
• Searching the Sky—the receiver is looking for satellites.
• AutoLocate—the receiver is looking for any satellite whose
almanac has been collected, which can take up to 5 minutes.
• Acquiring Satellites—the receiver is looking for and
collecting data from satellites visible at its last known or
initialized position, but has not acquired a fix.
• 2D GPS Location: At least three satellites have been
acquired, and a two-dimensional position fix has been
calculated. "2D Differential" appears when you are receiving
DGPS corrections in 2D mode, and a "D" appears on the
strength bar of satellites being corrected.
• 3D GPS Location: At least four satellites have been
acquired, and a three-dimensional fix has been calculated.
"3D Differential" appears when you are receiving DGPS
corrections in 3D mode, and a "D" appears on the strength bar
of satellites being corrected.
• Lost Satellite Reception—the receiver is no longer tracking
enough satellites for a 2D or 3D fix.
• Receiver Not Usable—the receiver is unusable, possibly due
to interference or abnormal satellite conditions. Turn the unit
off and back on to reset.
• Simulating GPS—the receiver is in simulator mode.
• GPS Off—the GPS receiver is turned off.
>
G
S
S
ETTING
ATELLITE
IGNALS
5
1/13/2005 10:43:24 AM

Advertisement

Table of Contents
loading

Table of Contents