Specifications - Pioneer LX01BD Operating Instructions Manual

Message
10
HDMI C.ERR 1**
Noisy!
Error MIC!
Error Speaker!
Over Temp
OC Error1
OC Error2
*** BackUpERR

Specifications

 Audio Multi-channel Receiver Subwoofer
Model
Rated voltage
Rated frequency
Power consumption
Power consumption (standby)
Weight
External dimensions (including projecting parts)
Tolerable operating temperature
Tolerable operating humidity
Amplifier section:
RMS Power Output
(8 channel output)
FM tuner section
AM tuner section
Subwoofer section
HDMI terminal
Other connector
Display unit
54
En
Description
Check if the HDMI cable is properly connected. If the cable is properly connected, this unit may be damaged.
In such an event, please contact a Pioneer-authorized service center or your nearest dealer.
Background noise is too high to complete MCACC setup successfully.
An error occurred during MCACC setup because the microphone is not connected or is not connected properly.
An error occurred during MCACC setup because the speakers are not connected or are not connected properly.
Try lowering the volume. If this problem is not fixed by removing and inserting the power cable, this unit may
be damaged. In such an event, please contact a Pioneer-authorized service center or your nearest dealer.
Check whether the speaker cables are short-circuited. If the error message continues to be displayed, contact
your Pioneer authorized service center or your dealer for servicing.
Contact your Pioneer authorized service center or your dealer for servicing.
Front, Center, Surround (6 channel)
Dual Subwoofer (2 channel)
Frequency range
Antenna
Frequency range
Antenna
Enclosure
System
Speaker
Nominal impedance
Frequency range
Maximum Input Power
Input
Output
System connector
Audio input
Control output
System connector
Front Audio input
MCACC input
iPod input
SX-LX70SW
AC 220 V to 240 V
50 Hz/60 Hz
69 W
0.39 W (HDMI Control ON)
0.29 W (HDMI Control OFF)
17.8 kg
245 mm (W) x 409 mm (H) x 600 mm (D)
+5 °C to +35 °C
5 % to 85 % (no condensation)
50 W per channel (1 kHz, 10 % T.H.D., 8 Ω)
100 W (50 W+ 50 W) (100 Hz, 10 % T.H.D., 8 Ω)
87.5 MHz to 108 MHz
75 Ω, unbalanced
531 kHz to 1602 kHz
Loop antenna
Bass-reflex floor type (magnetically shielded)
18 cm 1-way system
18 cm cone type x2
8 Ω
30 Hz to 500 Hz
50 W x2
19 pin x3
19 pin (5 V, 100 mA)
26 pin
Optical x2 (Digital)
RCA (2 pin) (Analog)
Mini jack x2
26 pin
Mini jack
Mini jack
20 pin (12 V, 420 mA)