Surround Sound Settings; Using The Sound Setup Menu; Channel Level Setting; Speaker Distance Setting - Pioneer LX01BD Operating Instructions Manual

Chapter 7

Surround sound settings

Important
• Press SYSTEM CONTROL to set the remote control to receiver
control mode in order to operate the receiver subwoofer (make
sure that the LCD displays the SYSTEM screen, as shown
below).
GUIDE
TV
VOL
SYSTEM
SURR

Using the Sound Setup menu

From the Sound Setup menu you can access all the surround sound
settings of the system.
During setup, the speakers are represented by the following letters:
• L – Front left speaker
• C – Center speaker
• R – Front right speaker
• SR – Surround right speaker
• SL – Surround left speaker
• SW – Subwoofer

Channel level setting

The Auto MCACC feature (see page 26) should give you the best
surround sound setup. However you may find that by further
adjustment of the channel levels you can improve the surround
sound in your listening room.
This method of setting the channel levels allows you to listen to a
source and adjust the levels of each playback channel.
A further method of setting the channel levels is to use the test tone
method. See Adjusting the channel levels using the test tone on
page 39 for more on this.
1 Press SETUP.
HOME
MENU
SETUP SETUP
SYSTEM
INFO
MUTE
VOL
SYSTEM SYSTEM
CONTROL CONTROL
ADV. F.S.
SURR SURR
RETURN
2 Select 'Sound Setup'.
Use / to select, then press ENTER.
TOP MENU
DISC
NAVIGATOR
HOME
MENU
SETUP
3 Select 'ChannelLevel'.
Use / to select, then press ENTER.
Use / to select a channel, or use / to adjust the
4
level of that channel.
TOP MENU
DISC
NAVIGATOR
HOME
MENU
SETUP
• You can adjust the level of each channel by ±10 dB.
5 Press ENTER once when you're finished.
TOP MENU
DISC
NAVIGATOR
HOME
MENU
SETUP
• If you use the Auto MCACC feature again, it will overwrite the
settings you have made here.
Note
• When this function is set while MCACC Effect is on, the value
for the same function adjusted with the Auto MCACC feature is
overwritten.
When MCACC Effect is off, the value set here is applied,
regardless of the value adjusted with the Auto MCACC feature.
(The Auto MCACC setting is not overwritten.)
• The range of adjustment is limited when the volume level is set
over 51.

Speaker distance setting

The Auto MCACC feature (see page 26) should give you the best
surround sound setup. However you may find that by further
adjustment of the speaker distance settings you can improve the
surround sound in your listening room.
Set the distance of each speaker from your normal listening
position.
1 Press SETUP.
2 Select 'Sound Setup'.
Use / to select, then press ENTER.
3 Select 'Distance'.
Use / to select, then press ENTER.
TOOLS
MENU
RETURN
TOOLS
MENU
RETURN
TOOLS
MENU
RETURN
07
37
En