Basic Operation; Operating The Remote Control - Pioneer LX01BD Operating Instructions Manual

3 If the receiver subwoofer is off, press SYSTEM ON to turn
the power on.
ON ON
INPUT
HDMI 1 HDMI 2
BD DVR
4 Press SYSTEM CONTROL to set the remote control to
receiver control mode.
GUIDE
TV
VOL
Make sure that the LCD displays the SYSTEM screen, as shown below.
SYSTEM
SURR
5 Press MCACC.
MCACC MCACC
SLEEP
Try to be as quiet as possible after pressing MCACC. The volume
increases automatically and the system outputs a series of test
tones.
• To cancel Auto MCACC setup before it has finished, press
MCACC. The unit will continue to use the previous settings.
• If the ambient noise level is too high, Noisy! blinks in the display
for five seconds. To exit and check the noise levels, press
MCACC, or to try again, press ENTER when Retry shows in the
display.
• If you see an Error MIC! or Error Speaker! message in the
display, there may be a problem with your mic or the speaker
connections. To try again, press ENTER. (If this doesn't work,
press MCACC, turn off the power, and check the problem
indicated by the Error message, then try the Auto MCACC setup
again.)
• When the MCACC setup is complete, the volume level returns to
normal, Complete shows in the display, and MCACC Effect is
activated. (See Listening with MCACC Effect on page 33 to
switch on/off MCACC Effect.)
• Be sure to disconnect the microphone from this unit upon
completion of the Auto MCACC setup.
Note
• If the room environment is not optimal for the Auto MCACC
setup (too much ambient noise, echo off the walls, obstacles
blocking the speakers from the microphone) the final settings
may be incorrect. Check for household appliances (air
conditioner, fridge, fan, etc.), that may be affecting the
environment and switch them off if necessary.
• Some older TVs may interfere with the operation of the mic. If
this seems to be happening, switch off the TV during Auto
MCACC setup.
• If Complete doesn't appear, it is likely an error occurred during
the setup. Please check all connections and try again.
SYSTEM SYSTEM OFF
TV

HDMI 3
DVD TV
SYSTEM
INFO
MUTE
VOL
SYSTEM SYSTEM
CONTROL CONTROL
ADV. F.S.
SURR SURR
LINE
TEST
SOUND
TONE
EXIT

Basic operation

This manual is split into two parts, one covering using the receiver
subwoofer, the other using the Blu-ray disc player. Below are some
common operations and where to find them explained in this
manual.

Operating the remote control

The supplied remote control can control not only the receiver
subwoofer and Blu-ray disc player, but also other Pioneer products
such as Flat Screen TVs, HDD/DVD recorders, and DVD players.
To operate these components, orient the remote control toward the
display unit.
 Operating the receiver subwoofer
 Press SYSTEM CONTROL to display the SYSTEM screen.
The SYSTEM screen is shown on the remote control's LCD screen,
and the remote is switched to SYSTEM mode.
SYSTEM SYSTEM
SURR SURR
MCACC MCACC
SLEEP SLEEP
DISPLAY
TOP MENU
DISC
NAVIGATOR
HOME
MENU
SETUP
GUIDE
TV
VOL
ADV. ADV. F.S. F.S.
SURR SURR SURR SURR
SOUND SOUND
DIRECT DIRECT
RTRV RTRV
LINE LINE
TEST TEST
SOUND SOUND
TONE TONE
EXIT EXIT
LIGHT
PAGE
TOOLS
MENU
RETURN
SYSTEM
INFO
MUTE
VOL
SYSTEM SYSTEM
CONTROL CONTROL
04
27
En