Am Loop Antenna; Display Cable - Pioneer LX01BD Operating Instructions Manual

1 Connect the display unit to the receiver subwoofer.
Plug the display cable into the connector on the rear of the display
unit, then plug the other end of the display cable into SYSTEM
connector on the receiver subwoofer.
Caution
• Do not attempt to attach the display unit to the wall.
2 Assemble the AM loop antenna.
a b
a. Bend the stand in the direction indicated by the arrow.
b. Clip the loop onto the stand.
c. If you want to fix to a wall or other surface, perform step b after
first securing the stand with screws.
It is recommended that you determine the reception strength
before securing the stand with the screws.
3 Connect the AM and FM antennas.
a. Connect one wire of the AM loop antenna to each AM antenna
terminal.
For each terminal, press down on the tab to open; insert the
wire, then release to secure.
2
b. Push the FM antenna plug onto the center pin of the FM antenna
socket.
Note
• Keep antenna cables away from other cables, the display unit,
receiver subwoofer and Blu-ray disc player.
• If reception with the supplied antenna is poor, see Improving
poor FM reception and Improving poor AM sound on page 34 or
Connecting external antennas on page 42.
• Do not attach any antenna other than the provided loop
antenna, or an external antenna as described on page 44.
• Don't let it come into contact with metal objects and avoid
placing near computers, television sets or other electrical
appliances.
• If radio reception is poor, you may be able improve it by re-
inserting each antenna wire into the opposite terminal.
• For best reception, do not untwist the AM loop antenna wires or
wrap them around the loop antenna.
• To ensure optimum reception, make sure the FM antenna is fully
extended and not coiled or hanging at the rear of the unit.
c
3
1
4 Connect each speaker.
• Each speaker cable has a color-coded connector at one end and
two wires at the other end.
• Twist and pull off the protective shields on each wire.
• Connect the wires to the speaker. Each speaker in the
illustration can be identified by means of the color-coded
indicator provided on the rear-surface model label. Match the
color-coded wire with the color indicator on the model label,
then insert the color-coded wire into the red (+) side and the
other wire into the black (–) side.
Black (–) Red (+)
• Connect the other end to the color-coded speaker terminals on
the side of the receiver subwoofer. Make sure to insert
completely.
Be careful when inserting the speaker plug, as it must be
inserted in the proper direction when being plugged into one of
the terminals. Please make sure to connect correctly.
Caution
• These speaker terminals carry HAZARDOUS LIVE voltage. To
prevent the risk of electric shock when connecting or
disconnecting the speaker cables, disconnect the power cord
before touching any uninsulated parts.
• Do not connect any speakers other than those supplied to this
system.
• Do not connect the supplied speakers to any amplifier other
than the one supplied with this system. Connection to any other
amplifier may result in malfunction or fire.
• After connecting the plugs, pull lightly on the cables to make
sure that the ends of the cables are securely connected to the
terminals. Poor connections can create noise and interruptions
in the sound.
• If the cables' wires happen to be pushed out of the terminals,
allowing the wires to come into contact with each other, it
places an excessive additional load on the amp. This may cause
the amp to stop functioning, and may even damage the amp.
Color-coded wire
(Connect to speaker)
Color-coded connector
(Connect to receiver subwoofer)
Color-coded wire
02
13
En