Using Function Button - Panasonic TH-42BT300W Operating Instructions Manual

Using FUNCTION button

Assigning functions to the FUNCTION button on the remote control enables a user to switch
between show/hide and modes with just a single touch of a button. The function settings are
confi gured by using "Function Button Settings" in the Setup menu (see page 56).
The button functions are confi gured in two ways depending on the setting (On/Off) of "Studio
mode" in the Options menu. Similarly, factory default settings vary as follows.
Factory default settings
FUNCTION Button 1
FUNCTION Button 2
FUNCTION Button 3
FUNCTION Button 4
FUNCTION Button 5
FUNCTION Button 6
FUNCTION Button 7
FUNCTION Button 8
Display of the FUNCTION button guide
Pressing the FUNCTION button can display the FUNCTION button guide to refer for the function of each button.
Function
1:Waveform Monitor
5:3D Settings
If the guide display is not needed, set "Function Button Guide" in "Function Button Settings" to "Off" (see page 56).
3D Settings / Signal / Colour gamut
Scrolling bar / Test Patterns
Scrolling bar
•
Activates the "Scrolling bar only" screensaver. After
15 minutes, the display enters standby mode.
To exit this mode, press any button.
Note:
"PC Power management", "DVI-D Power management" and "No signal power off" are deactivated during "Scrolling
bar" or "Test Patterns" operation. (see page 42)
Studio mode: On
Waveform Monitor
Marker settings
HV Delay
Blue only
3D Settings
Signal
Colour gamut
Scrolling bar
2:Marker settings 3:HV Delay
6:Signal 7:Colour gamut
The menu is displayed.
(Example: 3D Settings)
3D Settings
3D Function On
3D Picture Format Auto
3D Viewing Mode 3D
3D Picture Sequence Normal
3D Colour Compensation On
Safety Precautions
Pressing the FUNCTION button clears the menu.
Confi rmation screen (Example: Scrolling bar)
Function
Scrolling bar
Yes No
Studio mode: Off
Off timer
External scaler mode
Test Patterns
Blue only
3D Settings
Signal
Colour gamut
Scrolling bar
The operation starts.
4:Blue only
8:Scrolling bar
Press to select
The operation starts.
"Yes".
Press.
Test Patterns
•
Each time you press , a different test pattern is displayed
(seven in all).
Color Bars
Black 1% window
To exit this mode, press any button other than
Red Green
Frame
(2 lines × 2 dots) Blue
.
63