Panasonic TH-42BT300W Operating Instructions Manual page 28

Adjusting Pos. /Size
● Over scan Turn image over scan On/Off.
Confi gurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, RGB, DVI, SDI, HDMI)
Notes:
• When "Off" is set, "H-Size" and "V-Size" cannot be adjusted.
• When the "Display size" is set to "On" in the Options menu, this setting will be invalid.
● Clamp Position (During Component/PC input signal)
Adjusts the clamp position when black parts of the image have no detail due to underexposure
or are tinged with green.
Optimum value for Clamp Position adjustment
When black parts have no detail due to underexposure (blackout)
→ Value that causes least blackout is the optimum.
When black parts are tinged with green
→ Value that cancels the greenishness without causing blackout is the optimum.
● 1:1 Pixel Mode Adjusts the display size when 1125i, 1125p or 1250i signal is input.
Notes:
• Select On when you would like to replay 1920 × 1080 input signal.
• Applicable input signal;
1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p, 1250 (1080) / 50i
• Select Off when fl ickering is shown around the image.
• H-Size and V-Size cannot be adjusted when On is selected.
● 1:1 Pixel Mode (2k1k)
(For 2k1k signals)
Off
Note:
2k1k signals can only be received when the Dual Link HD-SDI Terminal Board (TY-FB11DHD) or the Dual
HD-SDI Terminal Board for 3D (TY-FB30DHD3D) is installed.
● HV Delay (During Component [video format] / SDI input signal)
Video blanking period is displayed.
Off
Notes:
• This function is enabled when "Studio mode" in Options menu is set to "On" during 2D viewing.
• This function can also be used with the FUNCTION button on the remote control (see page 63).
28
On
When the input signal is a 2k1k signal (2048 × 1080 / 24p, 2048 × 1080 / 24sF), the
display size is adjusted as follows.
On (Left)
H Delay
Off
Off
On (Centre)
V Delay
On
On (Right)
HV Delay