GE JCP67 Use And Care & Installation Manual page 33

initiation relationship of the ranges to the
Please note the following:
The
back of the range maybe instiled
1.
2. ~ese ranges conform to W requirements for
reduce possible scorching ofvertid wds and to
surface unit use conditions such as high heat or
no pans, a minimum of 2" spacing should be
provided on both sides of the cooktop.
3. To etiate the h-d of reaching over
heated surface units, cabinet storage space
located above the surface units should be
avoided. E a cabinet is to be provided, the hwd
projects hotiontiy a minimum of 5" beyond
the bottom of the cabinets.
This range
must be properly secured to the
floor by using the included anti-tip brackek and
screws. Fdure to insti the brackets cotid ~ow
the range to accidentiy tip over if excessive
weight is placed on an open door or if a ctid
to the instructions below for proper ks~tion.
location, the anti-tip brackets must dso be
moved and kstied with the range.
Tools Rqtied:
5/16" Nutdriver or Nat Head Screwdriver
Adjustable Wrench
3/16" Diameter Masonry Dfl (ifins~g
in concrete)
Brackets a~ch to the floor at the back of tie range
to hold boti rear leg levelers. When fastening to
1. Unfold the paper template and pb it fit on
be lomted when instied. ~se the diagram to
2. Mark on the floor the location of the 4
1/2" deep m be ~ed into the floor.
3. Remove tie template and place the brackets
he floor and attach with the 4 screws provided.
ear legs are trapped by the ends of the brackets.
ideas it is being pushed back to dow the rear
I
I
33