GE JCP67 Use And Care & Installation Manual page 27

Control Panel and fiobs
Clean
up any spills or spattem with a damp cloth.
Remove heavier soil with warm, soapy water.
Clean control panel with mild liquid dish detergent
and a soft cloth. Rub wntrol panel lightly.
on the control panel.
Clean the area under the cooktop often. Built-up soil,
especially grease, may catch fire.
To make cleaning easier, the entire cooktop may be
lifted up and supported in the up position.
Be sure W surface units are turned off before
raising the cootip. Grasp the front sides of the
not ne~d to be removed before raising :tie '~oktop,
however, you may remove one to make raising the
Cleaning Under the Mnge
The area under the range can be reached eastiy
for cleaning by removing the bottom drawer.
To remove, pull the drawer out dl the way, tilt up the
front and remove it. To replace, insert @ides at the
back of the drawer beyond the stop on range @ides.
Lift the drawer if nwssary to insert easdy. tit the
front of the drawer down, then push in to close.
Press the backsplash light switch for ON.
Press again for O=.
To replace the light Iomted in the backsplash:
If the light cover has screws, remove the four "
1.
screws that hold it in position. Two are located
on top of the backsplash and two are Ioated under
the backsplash overhang.
If there are no screws or after they are removed lift
2.
the cover away and twist out the fluores%nt light.
The control knobs may
be removed for easier
cleaning. To remove a
knob, pdl it straight off
the stem. Wash the
knobs in soap and
water but do not soak.
To lifi the cooktop:
1. Remove dl items
which may slide off
the cooktop.
2. With both hands,
grasp the front edge
of the cooktop.
3. Lift the cooktop.
4. Raise the support rod and let the cooktop rest on it.
Clean under the coo~p with
and a clean cloth.
To lower the cootip:
1. Lift the
Lower the moktop and allow it to lock into position.
2.
Be sure the light is cool before removing.
3. Insert the new fluorescent light and twist into the
lock position. (Check to make sure the new light
operates. If no~ the light maybe blown.)
4. Replace the backsplash cover and reinsert the
screws that hold it into position (on some models).
27