GE JCP67 Use And Care & Installation Manual page 31

BEFORE YOU BEGIN
Read these instructions completely and carefu~y
and ordinances.
NOTE TO ~~~~ be these
instructions with the appfiance after
This
connected by mems
of
permanent
cord kit
It is the personal responsibtity of the customer
to contact a qu~ed technician to assure that
the electrid initiation is adequate and is in
conformance with the National Electrical Code
and 10A codes and ordinances.
ONLY. Numinum wire must
not be used to avoid potentidy msatisfactory
connections.
POWER SUPPLY CORD WT
This
power supply cord kit. Ordy a power supply cord
kit rated at 125/250 volts minimum, 40
and marked for use with ranges shd be
amps
used. Cord must have 3 conductors,
codes do not permit grounding through neuti,
a 4 conductor power supp~ cord kit rated at
125/250 VOltS minimum, 40 =PS and
marked for use with ranges sh~ be used.
Terminals on end of wires must be either closed
loop or open+nd spade lugs with upturned ends.
Cord must have strain rehef cbp.
POWER SUPPLY CORD
Some models may be equipped with a factory
connected 3 conductor power supply cord.
codes do not permit grounding through neutral,
a 4 conductor power supply cord kit rated at
125/250 VOltS minimum, 40 =PS and
investigated for use with ranges shd be used.
loop or open+nd spade lugs with upturned ends.
This apptiance is mandctured with the neuti
terminal connected to the frame.
1. Uld codes permit connetion of tie
wire of the copper power supply cord:
block cover ~ower part of the back wire cover).
terminal nuts are taped to the frame
B. me
below the terminal block
C. Connect the neuti wire of the copper
power supply cord to the center sflver colored
outer ties to the outer tetis. See Piie 1.
Ring type terminals must be used on copper
power supply cord wires.
D. Replace the terminal block cover.
FIGURE l(conttimpage)
31