GE JCP67 Use And Care & Installation Manual page 32

2. Mconnectingto a four-wire electrical system
(mobile home):
B. Remove the ground strap born the
terminal block and from the apptiance
frame. Reti the ground screw.
C. Connect the ground wire been) of the
copper power supply cord to the frame of
the apptiance with the ground screw, using
the hole in the frame where the ground
strap was removed. %e F~e 2.
D. Connect the neuti (white) wire of the
copper power supply cord to the center
block and connect the other wires to the
outer teds.
E. Replace the terrnind block cover.
FIGURE 2
32
To ehate the hward of reaching overheated
surface elements, mbinets or storage spaces
should not be provided over a range.
reduced by insfig a rmge hood that projects
of the cabinets.
refer to figure below for the ske of the opening
needed. Do not sed the range to cabinets.
should be located in accordance with the
dimensions below.
CORD.
I
Wall
I