Connecting the scanner to your PC
Follow the steps below to connect the EPSON FilmScan 200
(parallel interface model) to your PC.
Note:
Use a standard shielded, twisted-pair parallel interface cable.
1. Make sure that both the scanner and computer are turned
off and unplugged from any power source.
c
Caution:
Do not connect the scanner and computer while they are
turned on; otherwise damage may occur.
2. Connect the 25-pin end of the cable to the computer. Then
tighten the screws on the sides of the connector. Connect
the ground wire if your interface cable has one.
Connecting EPSON FilmScan 200 to Your Computer
2
2-3