Removing; Adjusting Footrest Height; Model Phwh93 - Invacare Pronto M41 Owner's Manual

Removing

1. Push the front rigging release lever inward and rotate the footrest out.
2. Lift up on front rigging and remove from the wheelchair.
3. Repeat STEPS 1‐2 for opposite side of wheelchair.

Adjusting Footrest Height

Model PHWH93

NOTE: For this procedure, refer to FIGURE 9.2.
1. Remove any accessories from the footrest(s).
2. Remove the footrest from the wheelchair. Refer to Installing/Removing Front Riggings
on page 44.
NOTE: Lay footrest on a flat surface to simplify section.
3. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the
footrest support.
4. Reposition the lower footrest to the desired height.
5. Reinstall hex bolt, coved washers and locknut that secure lower footrest to footrest
support. Tighten securely.
6. Repeat STEPS 1‐5 for the opposite side of the wheelchair footrest, if necessary.
7. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Front
Riggings on page 44.
8. Reinstall any accessories onto the footrest(s).
Locknut
Coved Washer
FIGURE 9.2 Adjusting Footrest Height - Model PHWH93
Part No. 1143206
SECTION 9—FRONT RIGGINGS
Footrest Support
Coved Washer
Hex Bolt
Lower Footrest
45
Pronto® M41 with SureStep®