SECTION 7—SEAT AND BACK
SECTION 7—SEAT AND BACK
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.
NOTE: The procedures in this section of the manual apply to non‐recliner seat frames only except
where noted.
Replacing the Locking Mechanism in the Back Cane
The locking mechanism in the back canes is spring loaded. Slowly remove the back
canes from the wheelchair to prevent the springs from being lost.
NOTE: For this procedure, refer to FIGURE 7.1.
1. Fold the back canes down and out of the way. Refer to Folding/Unfolding the Back
Canes on page 56.
2. Twist the actuator counterclockwise to remove from the locking mechanism.
3. Slowly let the locking mechanism and spring slide out of the back cane.
NOTE: Inspect the spring for wear and damage. Replace if necessary.
4. Slide the new locking mechanism and spring into the back cane.
5. Make sure the angled end of the locking mechanism is pointing up towards the
locking pin on the adjustment plate.
6. Use Loctite™ 242, on threads only, and securely tighten the actuator into the locking
mechanism.
7. Unfold the back canes. Refer to Folding/Unfolding the Back Canes on page 56.
FIGURE 7.1 Replacing the Locking Mechanism in the Back Cane
™
Orbit
WARNING
CAUTION
Spring
Locking
Mechanism
52
Back Cane
Actuator
Angled Portion of
Locking
Mechanism
Part No. 1073955