Adjusting Footplate Height; Spring Button; Bolt-In-Place - Invacare Tracer EX2 Owner's Operator And Maintenance Manual

SECTION 4—FRONT RIGGINGS

Adjusting Footplate Height

Spring Button

NOTE: For this procedure, refer to FIGURE 4.2.
NOTE: This procedure applies to the swingaway front riggings and swingaway elevating legrest.
1. Remove the front rigging assembly. Refer to Installing/Removing Front Riggings on
page 29.
NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.
2. Pull the cam lock lever up to unlocked
position.
NOTE: The elevating legrest has two sets of
release buttons, one set above the other. Each set
will be visible one at a time allowing finer
footplate height adjustment.
3. Push in the release buttons and
reposition the footplate assembly to the
desired height.
4. Ensure that the release buttons fully
protrude from holes on both sides of
the front rigging support.
5. Rotate cam lock lever down to locked
position.
6. Repeat this procedure for the other
footplate, if necessary.
7. Reinstall the swingaway front rigging assembly. Refer to Installing/Removing Front
Riggings on page 29.

Bolt-In-Place

NOTE: For this procedure, refer to FIGURE 4.3 on page 31.
NOTE: This procedure applies to the swingaway footrests and swingaway elevating legrest.
1. Remove the swingaway front rigging. Refer to Installing/Removing Front Riggings on
page 29.
NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.
2. Pull the cam lock lever up to the unlocked position.
3. Using a screw driver to hold the threaded rivet in position, remove the button head
screw from the threaded rivet.
4. Remove the threaded rivet and button head screw securing the footplate assembly to
the front rigging support.
®
Tracer EX2
Adjustment
Holes
Cam Lock Lever
NOTE: Swingaway footrest shown.
FIGURE 4.2 Spring Button
30
Front Rigging Support
Release Button
Footplate
Assembly
Part No. 1110546