Installing Crutch And Cane Carrier - Invacare Tracer EX2 Owner's Operator And Maintenance Manual

SECTION 11—OPTIONS
Bracket "B"
Bracket "A"
Locknuts
Right
Left
Adult Right
Adult Left
Axle Spacer Toward
Axle Spacer Toward
Outside of Wheelchair
Outside of Wheelchair
Rear View of
Amputee Bracket
Hex Screws
Hemi Left
Hemi Right
FIGURE 11.1 Installing Amputee Bracket

Installing Crutch and Cane Carrier

WARNING
Check base weekly to ensure proper placement.
When loading the crutch/cane carrier, ensure items are securely placed into the
base. Also ensure that there is no interference with folding the wheelchair, the rear
wheels, or the swing-back arms.
Strap must be securely fastened while carrying items.
NEVER insert or remove items while wheelchair is moving.
NOTE: For this procedure, refer to FIGURE 11.2 on page 54.
1. Slide the clamp with the base attached over the end of the step tube of the wheelchair.
Ensure the base is towards the inside of the wheelchair.
2. Position the base parallel to the step tube.
CAUTION
Base should be parallel to step tube to avoid bending spokes when folding the wheel-
chair.
3. Securely tighten the locknut that secures the base to the step tube of the wheelchair.
4. Remove the upper back upholstery screw and washer.
5. Align the strap with the back upholstery screw mounting hole.
53 ®
Part No. 1110546 Tracer EX2