Fixed Frame - Invacare Tracer EX2 Owner's Operator And Maintenance Manual

5. Adjust the footplate assembly height by aligning the desired adjustment holes in the
upper front rigging support and lower footplate assembly.
6. From the outside of the swingaway front rigging, insert the threaded rivet through
both the front rigging support and the footplate assembly.
7. From the inside of the swingaway front rigging, insert the button head screw through
the appropriate adjustment hole and thread into the threaded rivet.
8. Using a screwdriver to hold the threaded rivet in position, securely tighten the button
head screw. Torque to 32 in-lbs.
9. Rotate cam lock lever down to locked position.
10. Repeat STEPS 1-9 to adjust the remaining footrest.
Button Head
Screw
Adjustment
Hole
Cam Lock
Lever
Inside of
Swingaway
Front Rigging

Fixed Frame

NOTE: For this procedure, refer to FIGURE 4.4
1. Remove impact guards and/or calf strap, if necessary.
2. Loosen, but do not remove the bolt and
locknut that secure the lower footrest
assembly to the upper footrest support.
3. Reposition the lower footrest assembly
to the desired height.
4. Securely tighten the bolt and locknut.
5. Repeat this procedure for the other
footrest, if necessary.
6. Replace impact guards and/or calf
strap, if necessary.
Part No. 1110546
Front Rigging
Front Rigging
Support
Support
Button Head
Screw
Threaded Rivet
Footplate
Assembly
Outside of
Swingaway
Front Rigging
FIGURE 4.3 Bolt-In-Place
31
SECTION 4—FRONT RIGGINGS
Adjustment
Hole
NOTE: Swingaway footrest shown.
Wheelchair
Frame
Footplate
Assembly
Bolt and
Locknut
FIGURE 4.4 Fixed Frame
Threaded
Rivet
Footplate
Assembly
®
Tracer EX2