Removing/Installing Armrests; Removing Armrest; Installing Armrest - Invacare Tracer EX2 Owner's Operator And Maintenance Manual

SECTION 5—ARMS

Removing/Installing Armrests

Make sure the armrest release lever is in the locked position before using the wheel-
chair.
NOTE: For this procedure, refer to FIGURE 5.2.

Removing Armrest

1. Push down on armrest to ensure it is fully seated in front and rear sockets.
NOTE: STEP 1 prevents the release buttons from hanging up on the sockets during removal.
2. Unlock the rear armrest by rotating the armrest release lever towards the inside of the
wheelchair.
3. Press in the armrest release button at the front of the armrest.
4. While pressing in the armrest release button, remove the armrest from the arm sockets
by pulling straight up.

Installing Armrest

NOTE: Rear armrest release lever must be in the unlocked position when installing the armrest.
1. Position the armrest just above the front and rear arm sockets.
2. Push arm down evenly at the front and rear until the front armrest release button
snaps into the front arm socket.
3. Lock rear armrest by turning the armrest release lever towards the outside of the
wheelchair.
4. Ensure armrest is locked securely in the arm sockets by gently lifting up. If not locked,
repeat STEPS 1-3.
Armrest Release Handle
REAR Arm
Socket
®
Tracer EX2
WARNING
FIGURE 5.2 Removing/Installing Armrests
36
Armrest
Armrest
Release Button
FRONT
Arm Socket
Part No. 1110546