HP NetServer AA 4000 Administrator's Manual page 241

Chapter 9
Note: For detailed instructions, refer to the
Guide.
Step Action
1 If required, fasten the rackmount brackets
and install the IOP in the rack.
2 Attach the following cables to the IOP:
• The power cord.
• The MIC cable.
• The Ethernet cable that connects the IOP
to the public Ethernet network.
• The IL cable.
• The video cable, the keyboard, and the
mouse.
3 Plug in the power cord.
4 Power up the new IOP.
5 If you installed the IOP boot disk from the
IOP that you replaced, continue with Step 6.
HP NetServer AA Solution Installation
Notes
Otherwise, install Windows NT and Endurance
software as described in Chapter 3
AA Solution Installation Guide.
• Installing Windows NT.
• Installing Endurance software only for this IOP.
• Using the Endurance Configuration Utility to make
any appropriate changes to the configuration. If the
configuration has changes, you must update the
configuration on both IOPs. Refer to
information.
Maintenance
of the HP NetServer
This includes:
Chapter 6 for
225