Iopn.ethernetx Enable Operation; Iopn.ethernetx Reset Port Counters - HP NetServer AA 4000 Administrator's Manual

Chapter 5

IOPn.Ethernetx Enable Operation

This command enables an Ethernet adapter that was disabled.
Note: For information on enabling a faulted Ethernet adapter, refer to
Command IOPn.Ethernetx Enable Operation
Console Syntax MTCCONS IOPn.ETHERNETx Enable Operation
n – the ID number of the IOP (1 or 2)
Variables
x – the ID number of the Ethernet adapter
Results Check the Windows NT Event Viewer on the CE for the following message:
See Also
IOPn.Ethernetx Disable Operation

IOPn.Ethernetx Reset Port Counters

The Ethernet Provider maintains error counters and statistics for each configured Ethernet
adapter. This command initializes the counters to zero for the specified adapter on the specified
IOP. This command has no effect on the counters maintained by the third-party Ethernet adapter
driver.
Command IOPn.Ethernetx Reset Port Counters
Console Syntax MTCCONS IOPn.ETHERNETx Reset Port Counters
Variables n – the ID number of the IOP (1 or 2)
x – the ID number of the Ethernet adapter
See Also
IOPn.Ethernetx Show Port Counters
114
IOPn.MtcDsl status: Physical device Ethernet adapter on IOPn of
logical device Ethernetx on IOPn is online.
Commands
Chapter 9.