Ipv6 Is-Is Configuration Examples; Ipv6 Is-Is Basic Configuration Example - HP 6125XLG Configuration Manual

IPv6 IS-IS configuration examples

IPv6 IS-IS basic configuration example

Network requirements
As shown in
same AS. Configure IPv6 IS-IS on the switches so that they can reach each other.
Switch A and Switch B are Level- 1 switches, Switch D is a Level-2 switch, and Switch C is a Level- 1 -2 switch.
Figure 81 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure IPv6 IS-IS:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] isis 1
[SwitchA-isis-1] is-level level-1
[SwitchA-isis-1] network-entity 10.0000.0000.0001.00
[SwitchA-isis-1] ipv6 enable
[SwitchA-isis-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] isis ipv6 enable 1
[SwitchA-Vlan-interface100] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] isis 1
[SwitchB-isis-1] is-level level-1
[SwitchB-isis-1] network-entity 10.0000.0000.0002.00
[SwitchB-isis-1] ipv6 enable
[SwitchB-isis-1] quit
[SwitchB] interface vlan-interface 200
[SwitchB-Vlan-interface200] isis ipv6 enable 1
[SwitchB-Vlan-interface200] quit
Figure 81, Switch A, Switch B, Switch C, and Switch D, all enabled with IPv6, reside in the
331