HP 6125XLG Configuration Manual page 276

[SwitchC-bgp-ipv6] peer 3000::1 enable
[SwitchC-bgp-ipv6] peer 2000::1 enable
[SwitchC-bgp-ipv6] quit
# Enable BFD for peer 3001::1.
[SwitchC-bgp] peer 3000::1 bfd
[SwitchC-bgp] quit
[SwitchC] quit
Verifying the configuration
# Display detailed BFD session information on Switch C.
<SwitchC> display bfd session verbose
Total Session Num: 1
IPv6 Session Working Under Ctrl Mode:
Local Discr: 513
Source IP: 3001::3
Destination IP: 3000::1
Session State: Up
Min Tx Inter: 500ms
Min Rx Inter: 500ms
Connect Type: Indirect
Hold Time: 2243ms
Detect Mode: Async
Diag Info: No Diagnostic
The output shows that a BFD session has been established between Switch A and Switch C.
# Display BGP peer information on Switch C.
<SwitchC> display bgp peer ipv6
BGP local router ID: 3.3.3.3
Local AS number: 200
Total number of peers: 2
Peer
2000::1
3000::1
The output shows that Switch C has established two BGP connections with Switch A, and both
connections are in Established state.
# Display route 1200::0/64 on Switch C.
<SwitchC> display ipv6 routing-table 1200::0 64 verbose
Summary Count : 1
Destination: 1200::/64
Up Session Num: 1
Rx Count: 13
Protocol: BGP6
AS
200
200
Init Mode: Active
Remote Discr: 513
Interface: N/A
Act Tx Inter: 500ms
Detect Inter: 2500ms
Tx Count: 14
Running Up for: 00:00:05
Auth mode: None
Peers in established state: 2
MsgRcvd MsgSent OutQ PrefRcv Up/Down
8 8
5 4
265
Slot: 0
0 0 00:04:45 Established
0 0 00:01:53 Established
State