Configuring Basic Rip; Enabling Rip - HP 6125XLG Configuration Manual

Tasks at a glance
(Optional.)
•
Configuring an additional routing metric
•
Configuring RIPv2 route summarization
•
Disabling host route reception
•
Advertising a default route
•
Configuring received/redistributed route filtering
•
Configuring a preference for RIP
•
Configuring RIP route redistribution
(Optional.)
•
Configuring RIP timers
•
Configuring split horizon and poison reverse
•
Configuring the maximum number of ECMP routes
•
Enabling zero field check on incoming RIPv1 messages
•
Enabling source IP address check on incoming RIP updates
•
Configuring RIPv2 message authentication
•
Configuring the RIP packet sending rate
(Optional.)
(Optional.)
(Optional.)

Configuring basic RIP

Before you configure basic RIP settings, complete the following tasks:
Configure the link layer protocol.
•
Configure IP addresses for interfaces to ensure IP connectivity between neighboring routers.
•

Enabling RIP

Perform this task to create a RIP process and enable the RIP process on the interface attached to the
specified network. An interface that is not on the specified network does not run RIP.
To enable multiple RIP processes on a router, you must specify an ID for each process. A RIP process ID
has only local significance. Two RIP routers having different process IDs can also exchange RIP packets.
If you configure RIP settings in interface view before enabling RIP, the settings do not take effect until RIP
is enabled. If a physical interface is attached to multiple networks, you cannot advertise these networks
in different RIP processes.
To enable RIP:
Step
1. Enter system view.
2. Create a RIP process and
enter RIP view.
Configuring RIP route control:
Tuning and optimizing RIP
Configuring RIP GR
Configuring BFD for RIP
Configuring RIP FRR
networks:
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
22
Remarks
N/A
By default, no RIP process is
enabled.