Ipv6-Based Vrrp Configuration Examples; Single Vrrp Group Configuration Example - HP A5830 series Configuration Manual

Run Mode
Run Method
Total number of virtual routers : 2
Interface Vlan-interface2
VRID
Admin Status
Config Pri
Preempt Mode
Become Master
Auth Type
Virtual IP
Master IP
Interface Vlan-interface3
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
The output shows that in VRRP group 1 Switch A is the master, Switch B is the backup and hosts with the
default gateway of 202.38.160.100/25 accesses the Internet through Switch A; in VRRP group 2
Switch A is the backup, Switch B is the master and hosts with the default gateway of
202.38.160.200/25 accesses the Internet through Switch B.

IPv6-based VRRP configuration examples

This section provides these configuration examples:

Single VRRP group configuration example

•
VRRP interface tracking configuration example
•
VRRP with multiple VLANs configuration example
•
Single VRRP group configuration example
Network requirements
Switch A and Switch B belong to VRRP group 1 with the virtual IP addresses of 1::10/64 and
•
FE80::10.
Host A wants to access Host B on the Internet, and learns 1::10/64 as its default gateway through
•
RA messages sent by the switches.
When Switch A operates normally, packets sent from Host A to Host B are forwarded by Switch A;
•
when Switch A fails, packets sent from Host A to Host B are forwarded by Switch B.
: Standard
: Virtual MAC
: 1 Adver Timer
: Up State
: 100 Running Pri
: Yes Delay Time
: 2200ms left
: None
: 202.38.160.100
: 202.38.160.1
: 2 Adver Timer
: Up State
: 110 Running Pri
: Yes Delay Time
: None
: 202.38.160.200
: 0000-5e00-0102
: 202.38.160.131
141
: 1
: Backup
: 100
: 0
: 1
: Master
: 110
: 0