Configuring An Inner-Outer Vlan 802.1P Priority Mapping - HP 3600 v2 series Configuration Manual

Configure a traffic behavior to tag packets with an outer VLAN tag.
•
Create a QoS policy and associate the class with the behavior in the policy.
•
Apply the QoS policy to the port that connects to the user.
•
Follow these steps to configure selective QinQ:
To do...
Enter system view
Create a class and enter class view
Specify the inner VLAN IDs of
matching frames
Return to system view
Create a traffic behavior and enter
traffic behavior view
Specify an outer VLAN ID
Return to system view
Create a QoS policy and enter
QoS policy view
Associate the traffic class with the
traffic behavior defined earlier
Return to system view
Enter Layer 2 Ethernet interface
view or port group view of the
customer network-side port
Enable basic QinQ
Apply the QoS policy to the
incoming traffic
CAUTION:
Selective QinQ has higher priority than basic QinQ. A received frame is tagged with an outer VLAN ID
•
based on basic QinQ only after it fails to match the match criteria defined in the traffic class.
Selective QinQ is achieved through QoS policies. For more information about QoS policies, see ACL
•
and QoS Configuration Guide.

Configuring an inner-outer VLAN 802.1p priority mapping

Through QoS policies, the 3600 v2 Switch Series achieves the following inner-outer VLAN 802.1p
priority mapping modes:
Use the command...
system-view
traffic classifier classifier-name
[ operator { and | or } ]
if-match customer-vlan-id
vlan-id-list
quit
traffic behavior behavior-name
nest top-most vlan-id vlan-id
quit
qos policy policy-name
classifier classifier-name behavior
behavior-name
quit
Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
Enter port group view:
port-group manual
port-group-name
qinq enable
qos apply policy policy-name
inbound
180
Remarks
—
Required
By default, the operator of a class
is AND.
Required
—
Required
Required
—
Required
Required
—
Required
Use either command.
Required
Required