Call Feature Setting; Dial Plan - ATCOM at810 User Manual

AT810 Series User Manual
RFC2833, and INFO. Defaults to RFC2833.

5.4.3 Call Feature Setting

Message Waiting: Whether to prompt if there is a voicemail.

Pickup Service Code: To set the code to pick up calls. Default to "*8".

UDP Keep Alive Enable: Once enabled, the phone will keep sending UDP packet to

the register port of the server to make sure the server is staying available.
UDP Keep Alive Intvl: To set the interval time to send UDP packet.

Default Ring: Select a default ring for the phone when there's an incoming call.

SRTP: Turn on or off the Secure Real Time Control Protocol. If on, support from the

server will be needed unless make IP calls.

5.4.4 Dial Plan

Dial Plan: Configure the dial plan for the SIP account.
The Dial Plan defines the way that how to transform the number user dialed to the real
dialed characters sequentially, the syntax of the dial plan is similar to MGCP's and
MEGACO's.
 Functions of dial plan are defined by the configurable parameters as follows:
A. Interdigit Long Timer---the details please refer to
B. Interdigit Short Timer---the details please refer to
C. Dial plan---Dial plan contains a series of digit sequences and rules, each rule is
been separated by "|"，"(" stands for start and ")" stands for end. The default dial
plan is "(xxxxxxxxxxxx.)".
 The phone will take actions as follows after the user input the number:
1. The call will be rejected if the number does not match the dial plan. For example,
according to the default rule, it only receives digits. If we input characters or
ATCOM TECHNOLOGY CO., LIMITED
Interdigit Long
Interdigit Short
www.atcom.cn
Timer.
Timer.
28