Mute; Call Hold; 3-Way Conference Call - ATCOM at810 User Manual

AT810 Series User Manual
1. A presses "Hold".
2. A dials C's number to ask whether C would answer the call from B.
3. If C agrees, then A presses "XFER" to transfer B's call to C.
 Blind transfer:
Blind transfer do not allow user to talk with the third part instead of ending the call
directly, it means to user that the call is over after the blind transfer.
If A is using AT810 talking with B, B want to speak to C with A's transfer. The
operation steps are:
1. A presses "XFER".
2. A dials C's number, then A will be hang up no matter C receives the call or not.

4.5 Mute

Once the "Mute" key is been pressed, no voice will be transported to the other part in the
call anymore. Such state will be kept, no matter user switches the mode among handset
mode and handfree mode and earphone mode, until the button "Mute" is been pressed
again.

4.6 Call Hold

User can hold the current call by pressing "Hold". To resume the call, user needs to press
soft "Hold" again. The functions are available under 3-way conference mode the same as
under normal mode. When the phone is in the situation of "Hold"，the call won't be hang
up, instead, the call will be kept holding.

4.7 3-way conference call

Steps of starting a 3-way conference call are as follows:
1. When A is using AT810 talking with B and they want to make conference call with C.
A or B just needs to press soft key "Conf", the other one in the call will be held, and then
the initiator dials C's number, presses "#" or "Dial" to make the call.
2. After C answers the call, the initiator presses "Conf" to begin the 3-way conference
call.
3. If the initiator hangs up directly before the 3-way conference call established, it will
be ended, and the others will be hanged up, too.
4. Anyone in the 3-way conference call can act as an initiator of a new 3-way
conference call. This initiator obeys the above rule number 3.
ATCOM TECHNOLOGY CO., LIMITED www.atcom.cn
18