Call Feature Setting - ATCOM AT820 User Manual

AT820 Series User Manual
C. AVT: enable or disable AVT codec support in this account.
D. G722: enable or disable G722 codec support in this account.
E. G723: enable or disable G723 codec support in this account.
F. G729ab: enable or disable G729ab codec support in this account.
G. iLBC: enable or disable iLBC codec support in this account.
H. G726-16: enable or disable G726-16 codec support in this account.
I. G726-24: enable or disable G726-24 codec support in this account.
J. G726-32: enable or disable G726-32 codec support in this account.
K. G726-40: enable or disable G726-40 codec support in this account.
L. Prefer Codec: Select a preferred codec for all calls, it will use the prefer codec to
create calls if the far end supports this codec. However, the actual codec used in a call
still depends on the outcome of the codec negotiation protocol.
M. User Prefer Codec Only: Whether to use the preferred codec only for all calls or not.
If select "Yes", the call may fail if the far end does not support this codec.
N. DTMF Tx Method: Select the method to transmit DTMF signals to the far end: InBand,
RFC2833, and INFO. Default to RFC2833.

5.4.3 Call Feature Setting

A. Message Waiting: Whether to prompt if there is a voicemail.
B. Voice Mail Number: If user sets a voicemail number, then user can just dial it to enter
the voicemail box.
C. Pickup Service Code: Set the code to pick up calls. Default to "*8".
D. UDP Keep Alive Enable: Once enabled, the phone will keep sending UDP packet to
the register port of the server to make sure the server is staying available.
E. UDP Keep Alive Intvl: Set the interval time to send UDP packet.
F. Default Ring: Select a default ring for the phone when there's an incoming call.
G. SRTP: Choose the mode of Secure Real Time Control Protocol. Supports from the
server will be needed.
ATCOM TECHNOLOGY CO., LIMITED www.atcom.cn
31