Touchscreen Multitouch Driver Installation; Touchscreen (Pqlabs) Multitouch Platform Content; Touchscreen Information; Calibration - Planar UltraLux Series Manual

Touchscreen MultiTouch Driver Installation

Touchscreen MultiTouch Driver Installation
1
2
3
4
Once driver installation is complete, the touchscreen is ready for use.

Touchscreen (PQLabs) MultiTouch Platform Content

The PQLabs Software is used for troubleshooting and calibration. The different
menus are described below.
1
2

Touchscreen Information

Calibration

Utility

26
With the PC on, plug in the USB memory stick to the USB drive.
Locate and open the USB drive.
Double-click on the "mt_driver_kitV4.1212RC2" to install the driver.
Follow installation prompts until driver installation is complete.
On the PC, select the Start menu, All Programs and then PQLabs Software.
Click on "MultiTouch Platform" to open the PQLabs MultiTouch Platform window.
• Serial Number – Displays the serial number of the connected touchscreen.
• Firmware Version – Displays the firmware version of the touchscreen selected
under the "Serial Number" dropdown menu.
• Touch Points – Displays the number of touch points for which the touchscreen
is capable.
• Status – Displays the current status of the touchscreen.
• Calibration – Starts a 4-point calibration of the touchscreen. Perform the
programmed touchscreen calibration process. At the conclusion of the
calibration routine your touchscreen device is ready to use and will perform
with accurately positioned touch points.
• Reset Calibration – Resets calibration to factory default settings.
• Diagnose – Starts the "MultiTouchDoctor" program. This can be used to
troubleshoot issues with the touchscreen.
Planar UltraLux Series Installation Guide