Planar UltraLux Series Manual page 56

Planar UltraLux Remote Monitoring
5
6
7
Note:
may need to point your browser at the new address.
8
50
b You do no need to fill in anything under the Static (non-DHCP) Network
Settings section. However, if you do, these settings will be used in the event
that the DHCP attempts to time out.
c Go to step .
6
Under the DHCP section, choose No, use static settings.
a In the Static (non-DHCP) Network Settings section, enter the IP address given
to you by the network administrator.
b Enter the Network mask, DNS server(s), and Gateway as instructed by the
network administrator.
c Go to step .
6
Scroll to the bottom of the page and click Confirm and apply new network
settings to receive the Confirm Network Change page.
Review the settings to make sure they are correct. Click OK, apply changes now
to receive the Applying Network Changes page. This shows the network settings
to be used.
If you have changed the static IP address or changed from static to DHCP setup, you
You may have to click the Refresh button on your browser to see the new name
in the upper left corner of the page.
Planar UltraLux Series Installation Guide