Planar UltraLux Series Manual page 39

28 Set Mute to "off"
29 Get Mute
30 Get Input Status
31 Set Color Space to full
color
32 Set Color space to SRGB 08 22 13 00 00 00 02 C1
33 Get Color Space
34 Do an Auto Adjust
35 Do Auto Color Adjust
36 Do a Reset
37 Get Blacklevel
Brightness
38 Set Blacklevel
Brightness
39 Get Auto Scan Status
40 Set Auto Scan to "on"
08 22 0A 00 00 00 00 CC
04 21 14 C7
04 21 07 D4
08 22 12 00 00 00 00 C4
04 21 15 C6
08 22 07 00 00 00 00 CF
08 22 08 00 00 00 00 CE
08 22 11 00 00 00 00 C5
04 21 17 C4
Set to 50: 08 22 16 00 00
00 32 8E
04 21 18 C3
08 22 17 00 00 00 01 BE
Planar UltraLux Series Installation Guide
deactivates Mute
If Mute has been changed by
OSD commands, returns "Mute =
value" where 0 is mute off and 1
is mute on; may not reflect
actual Mute settings if Mute
settings were changed by serial
commands (known bug)
returns "HDMI", "VGA", or "DPRx"
(if no source is present, returns
the last source searched...so use
the Get Power Status command
to check for active source)
color space set to full color
color space set to sRGB
returns "Color Space = value"
if VGA (analog) source is present,
a sync/timing auto adjust is
done
if VGA source is present, a gray
level auto adjust is done
restores all settings to their
factory defaults
returns "Brightness = value",
where value ranges from -350 to
350 (this scale is different from
the 0-255 scale used in the OSD)
sets the offset for the color range
to allow adjustment of the
definition of black (See HDMI
Full Range commands)
returns "Auto Scan = value",
where value is 1 (on) or 0 (off )
Sets Auto Scan on, where the
source inputs will continually be
checked for activity beginning
with the default or selected
source
RS232 Commands
33