Recall Data; Pulse Train Source/Read - Fluke 726 User Manual

726
Users Manual
Memory Locations
Figure 19. SAVE DATA Menu Showing Measurement
Memory Location 3, 1

Recall Data

To recall data:
Push S twice. The right side of the display
1.
changes to show RECL SETUP and RECALL DATA.
Push W to highlight RECL DATA (bottom right of the
2.
display).
Push S.
3.
Push Z to choose the desired memory location (top
4.
of the display).
The data saved in that first memory location now
appears. There can be different measurements
stored (1-5) for each memory location (1-8).
44
Save Data Mode Indicator
Data Point
S A V E
D A T A
1
bec46f.eps
Push Y or Z to select the correct data location
5.
(bottom right of display).
Push S to recall the data stored in that location.
6.
Push W to return to the same RECALL DATA
7.
location to see the next saved measurement, 2 of 5
for example.

Pulse Train Source/Read

Pulse Train Source/Read counts input pulses or sources
output pulses. Use the configuration menus to set the
frequency and output voltage. Refer to "Configuration
Menus" earlier in this manual. The number of counts is
set through the main display and cannot be changed
L
while sourcing pulses.
in this mode since ramping or stepping during a pulse
train is not relevant.
works as a trigger/stop key