Fluke 726 User Manual page 22

726
Users Manual
No Name
Cycles through :
E Slow repeating 0 % - 100 % - 0 % ramp
TRIGGER/STOP
L
P Fast repeating 0 % - 100 % - 0 % ramp
L
N Repeating 0 % - 100 % - 0 % ramp in 25 % steps
Used for the pulse train and totalizer functions.
Increases or decreases the source level.
XW Y Z
Cycles through the 2-, 3-, and 4-wire selections.
M
Return to
Moves through the memory locations of Calibrator setups.
Recall
Moves through the configuration menus.
S
Saves and recalls setups & data.
N
ENTER is used in the configuration menus.
ENTER
O C
Used to enter and navigate the configuration menus.
M
P
Cycles the Calibrator through MEASURE and SOURCE modes in the lower display.
Selects TC (thermocouple) measurement and sourcing function in the lower display. Repeated
Q T
pushes cycle through the thermocouple types.
Toggles between voltage, mA sourcing, or mA simulate functions in the lower display.
HART
R
V
Inserts a 250
Selects RTD (resistance temperature detector) measurement and sourcing function in lower
R
S
display. Repeated pushes cycle through the RTD types. Selects resistance mode.
Selects the pressure measurement and sourcing function. Repeated pushes cycle through the
U
T
different pressure units.
12
Table 4. Key Functions (cont.)
Description
resistor when in mA.