Calibration Data; In Case Of Difficulty; Service Center Calibration Or Repair - Fluke 753 Calibration Manual

753/754
Calibration Manual

Calibration Data

The date of the last calibration and verification shows on the calibration sticker and on
the calibration screen in Setup mode. The CAL. STATUS number on the sticker should
always match the Calibration Status number in the calibration screen. Calibration of the
Product is to be done by qualified personnel.

In Case of Difficulty

To avoid possible electric shock or personal injury, do not use
the Product if it operates abnormally. Protection may be
impaired. When in doubt, have the Product serviced.
If the display is blank or unreadable, but the beeper works when the Product is turned on,
make sure the brightness is correctly adjusted. To adjust the Intensity, see "Display
Intensity" in the Users Manual.
If the Product will not turn on, make sure the battery is not dead or disconnected from the
battery charger. If the Product receives power, the power button should be lit. If the
button is lit, but the Product does not power up, have the Product serviced. See "How to
Contact Fluke".

Service Center Calibration or Repair

Calibration, repairs, or servicing not included in this manual must be done only by
qualified service personnel. If the Product fails, examine the battery pack first, and
replace it if necessary.
Make sure that you operate the Product in accordance with the instructions in this
manual. If the Product is faulty, send a description of the failure with the Product.
Pressure modules do not need to accompany the Product unless the module is faulty also.
Be sure to pack the Product securely, using the original shipping container if it is
available. See "How to Contact Fluke" and the Warranty Statement.
36
XWWarning