Recall a Setup
To recall a setup:
Push S twice. The right side of the display
1.
changes to show RECL SETUP and RECALL DATA.
Push S again to RECL SETUP.
2.
Push Z to select the desired memory location (at the
3.
top of the LCD).
Push S to recall the setup from the proper
4.
memory location.
Multifunction Process Calibrator
Storing and Recalling Data
Up to 40 data samples can be stored in a nonvolatile
memory to be recalled for later use. A low battery
condition or a battery change does not jeopardize the
stored settings.
Storing Data
To store measurement data, use the following procedure,
refer to Figure 19.
1.
Take the desired measurement.
Push S. The right side of the display changes to
2.
show SAVE SETUP and SAVE DATA.
Press W to select SAVE DATA.
3.
Push S again. The open data point (bottom right
4.
of the display) flashes.
Use Y and Z to change the data point location (1-8).
5.
Push S to store the measurement and return the
6.
unit to the measurement mode. Figure 19 shows a
reading stored in memory location 3, data point 1.
Storing and Recalling Data
43