Lan Screen - ZyXEL Communications NBG-419N User Manual

Table 28 Status Screen: Access Point Mode
LABEL
Status
Rate
Summary
Packet Statistics
WLAN Station Status
8.4.0.1 Navigation Panel
Use the menu in the navigation panel to configure NBG-419N features in Access Point mode.
The following screen and table show the features you can configure in Access Point mode.
Figure 47 Menu: Access Point Mode
Refer to Table 27 on page 56

8.5 LAN Screen

Use this section to configure your LAN settings while in Access Point mode.
Click Network > LAN to see the screen below.
NBG-419N User's Guide
DESCRIPTION
For the LAN and WAN ports, this field displays Down (line is down) or Up (line is up
or connected).
For the WLAN, it displays Up when the WLAN is enabled or Down when the WLAN
is disabled.
For the LAN ports, this displays the port speed and duplex setting or N/A when the
line is disconnected.
For the WAN port, it displays the port speed and duplex setting if you're using
Ethernet encapsulation and Idle (line (ppp) idle), Dial (starting to trigger a call)
and Drop (dropping a call) if you're using PPPoE or PPTP encapsulation. This field
displays N/A when the line is disconnected.
For the WLAN, it displays the maximum transmission rate when the WLAN is
enabled and N/A when the WLAN is disabled.
Click Details... to go to the Monitor >
(Section 4.5 on page 37). Use this screen to view port status and packet specific
statistics.
Click Details... to go to the Monitor >
(Section 4.6 on page 38). Use this screen to view the wireless stations that are
currently associated to the NBG-419N.
for descriptions of the labels shown in the Navigation panel.
Chapter 8 Access Point Mode
Packet Statistics screen
WLAN Station Status screen
63