Pppoe Encapsulation - ZyXEL Communications NBG-419N User Manual

Table 48 Network > WAN > Internet Connection: Ethernet Encapsulation
LABEL
First DNS Server
Second DNS
Server
WAN MAC Address
Factory default
Clone the
computer's MAC
address - IP
Address
Set WAN MAC
Address
Apply
Reset

12.4.2 PPPoE Encapsulation

The NBG-419N supports PPPoE (Point-to-Point Protocol over Ethernet). PPPoE is an IETF standard
(RFC 2516) specifying how a personal computer (PC) interacts with a broadband modem (DSL,
cable, wireless, etc.) connection. The PPP over Ethernet option is for a dial-up connection using
PPPoE.
For the service provider, PPPoE offers an access and authentication method that works with existing
access control systems (for example Radius).
One of the benefits of PPPoE is the ability to let you access one of multiple network services, a
function known as dynamic service selection. This enables the service provider to easily create and
offer new IP services for individuals.
Operationally, PPPoE saves significant effort for both you and the ISP or carrier, as it requires no
specific configuration of the broadband modem at the customer site.
By implementing PPPoE directly on the NBG-419N (rather than individual computers), the
computers on the LAN do not need PPPoE software installed, since the NBG-419N does that part of
the task. Furthermore, with NAT, all of the LANs' computers will have access.
NBG-419N User's Guide
DESCRIPTION
Select From ISP if your ISP dynamically assigns DNS server information (and
the NBG-419N's WAN IP address). The field to the right displays the (read-only)
DNS server IP address that the ISP assigns.
Select User-Defined if you have the IP address of a DNS server. Enter the DNS
server's IP address in the field to the right. If you chose User-Defined, but
leave the IP address set to 0.0.0.0, User-Defined changes to None after you
click Apply. If you set a second choice to User-Defined, and enter the same IP
address, the second User-Defined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. If you do not
configure a DNS server, you must know the IP address of a computer in order to
access it.
The MAC address section allows users to configure the WAN port's MAC address
by either using the NBG-419N's MAC address, copying the MAC address from a
computer on your LAN or manually entering a MAC address.
Select Factory default to use the factory assigned default MAC Address.
Select Clone the computer's MAC address - IP Address and enter the IP
address of the computer on the LAN whose MAC you are cloning.
Select this option and enter the MAC address you want to use.
Click Apply to save your changes back to the NBG-419N.
Click Reset to begin configuring this screen afresh.
Chapter 12 WAN
107