Wisp Mode Status Screen - ZyXEL Communications NBG-419N User Manual

Chapter 9 WISP Mode
Note: After clicking Login, the Easy mode appears. Refer to
Easy mode screens. Click Expert mode to see the screens described in the sections
following this.

9.4 WISP Mode Status Screen

Click to open the status screen.
Figure 52 Status: WISP Mode
The following table describes the labels shown in the Status screen.
Table 30 Status Screen: WISP Mode
LABEL
Logout
Device Information
Host Name
Firmware Version
Sys OP Mode
68
DESCRIPTION
Click this at any time to exit the Web Configurator.
This is the System Name you enter in the Maintenance > General screen. It is
for identification purposes.
This is the firmware version and the date created.
This is the device mode (Section 5.1.2 on page
WISP Mode.
Section on page 41
39) to which the NBG-419N is set -
NBG-419N User's Guide
for the