Setting Your Nbg-416N To Client Bridge Mode - ZyXEL Communications NBG-416N User Manual

Chapter 4 Modes
Table 23 Menu: Universal Repeater Mode (continued)
LINK
LAN
Maintenance
System
Logs
Tools
Sys OP
Mode
Language

4.5 Setting your NBG-416N to Client Bridge Mode

Connect your computer to the LAN port of the NBG-416N.
1
The default LAN IP address of the NBG-416N is 192.168.1.1 in router mode
2
(192.168.1.2 by default in non-router mode). In router mode, the NBG-416N can
assign your computer an IP address, so you must set your computer to get an IP
address automatically (computer factory default) or give it a fixed IP address in
the range between 192.168.1.3 and 192.168.1.254.
56
TAB FUNCTION
Advanced This screen allows you to configure advanced wireless
settings.
QoS Use this screen to configure Wi-Fi Multimedia Quality of
Service (WMM QoS). WMM QoS allows you to prioritize
wireless traffic according to the delivery requirements of
individual services.
WPS Use this screen to configure WPS.
WPS Station Use this screen to add a wireless station using WPS.
Scheduling Use this screen to schedule the times the Wireless LAN is
enabled.
IP Use this screen to configure LAN IP address and subnet
mask.
General Use this screen to view and change administrative
settings such as system and domain names, password
and inactivity timer.
Time Setting Use this screen to change your NBG-416N's time and
date.
View Log Use this screen to view the logs for the categories that
you selected.
Firmware Use this screen to upload firmware to your NBG-416N.
Configuration Use this screen to backup and restore the configuration
or reset the factory defaults to your NBG-416N.
Restart This screen allows you to reboot the NBG-416N without
turning the power off.
General This screen allows you to select the device operation
mode: Router, Access Point, Client Bridge or
Universal Repeater.
Language This screen allows you to select the language you prefer.
NBG-416N User's Guide